Using a solar pool cover correctly—bubble side down, trimmed to fit, and removed before shocking—maximizes heat retention and can slash water evaporation by up to 95%.
A solar pool cover sounds simple: unroll it and let the sun do the work. But one common mistake—bubbles facing the sky instead of the water—can cut heat transfer and shorten the cover’s life. Here is the exact step order, including the trimming trick that keeps the cover snug against the coping, and the timing rule that stops pool chemicals from destroying the bubbles.
Unrolling and Orienting the Cover Correctly
The single most important detail: the bubble side must face down toward the water. The smooth side faces up. This orientation lets the bubbles float against the surface for maximum heat transfer and prevents UV damage to the bubble layer. Unpack the cover on a clean, flat area near the pool, then unroll it carefully—do not drag it across rough decking. Lay the finished edge along one side of the pool and the opposite edge across.
The Relaxation and Trimming Steps That Matter
Let the cover sit on the water for a few hours in direct sun before trimming. The material softens and conforms to the pool’s shape, which makes the trim more accurate. After the relaxation period, use sharp scissors and cut the cover right up against the pool’s interior coping—no gaps, no drape onto ledges. For rectangular and round pools, cut two opposite sides around the perimeter. For irregular shapes or steps, leave 2 to 3 inches of excess at first for minor adjustments, then trim to the final fit. Around ladders and features, cut with a curved angle rather than a sharp right angle; right angles create weak points that tear over time.
Once trimmed, use a pool brush to smooth the cover flat and push out any trapped air bubbles beneath it. If the cover drifts, place light weight tubes (the kind used for winter covers) around the perimeter—avoid heavy or sharp objects that could puncture the material.
When to Use and Remove the Cover
Use the cover whenever the pool is not in use, especially at night to insulate heat and during the day to reduce evaporation. The cover can cut evaporative water loss by up to 95% and reduce chemical usage by 30–60%. That is the primary payoff. But the cover must come off before you shock the pool: putting it on immediately after adding chlorine shock or water balancers makes the bubbles brittle and fragile. Wait until chlorine levels drop below 2.5 ppm and water has circulated for a few hours. Also remove it ahead of heavy storms or high winds to prevent flying debris from damaging the surface. Never leave the cover on during winter—cold temperatures cause the material to crack and separate.
Recommended Pool Cover Care and Storage
At the end of each swimming season, clean the cover, let it dry thoroughly, and store it in a clean, dry indoor location. Rolling the cover onto a solar cover reel during the season makes daily removal and reinstallation quick. At season’s end, fold or roll it loosely for storage—never leave it outside in freezing weather. The clear bubble-wrap polyethylene allows the most light to pass into the water; colored covers reflect light and reduce the heating benefit, so clear is the practical default for most pools.
FAQs
Does bubble side face up or down on a solar pool cover?
The bubble side must face down toward the water. This lets the bubbles float against the surface for heat transfer and protects them from UV damage. The smooth side faces the sky.
Can I leave the solar cover on while adding chemicals?
Remove the cover before shocking the pool. High chlorine levels from shock treatments can make the bubbles brittle. Wait until free chlorine drops below 2.5 ppm and the water has circulated for several hours before putting the cover back on.
How long does a solar pool cover last with proper care?
A well-maintained clear solar cover typically lasts two to four seasons. Storing it indoors during winter and removing it before chemical treatments extends its life significantly. UV exposure and improper storage are the main causes of early bubble failure.
References & Sources
- In The Swim. “Solar Pool Cover Installation, Use and Care.” Covers orientation, trimming, chemical compatibility, and seasonal storage.
- Inyo Pools. “How to Install an In-Ground Pool Solar Cover Reel.” Details on cover handling and avoiding cutting errors around steps.
