The biggest mistake men make when fitting a bra is measuring too high on the chest, above the pectoral muscles, which makes the band too small and painful. The right measurement point is about two inches below the nipples. From there, a simple add-4-or-5 formula and a cup calculation give the starting size, and a few minutes of checking the band and straps confirm whether the fit works.
The Two Measurements You Need
Wrap a soft measuring tape snugly around the torso two inches below the nipples, directly under the pectoral muscles, after exhaling, with the tape firm but not digging in. For the second measurement, wrap the tape around the fullest part of the chest — over the nipples or breast forms if worn — keeping it comfortably loose and level across the back. Write down both numbers in inches.
Calculating Your Band and Cup Size
Men with little or no breast tissue should follow this “+4 to +5” rule to avoid a band that digs into the ribs. Subtract the band size from the overbust measurement. The difference determines the cup:
- 1-inch difference = A cup
- 2-inch difference = B cup
- 3-inch difference = C cup
- 4-inch difference = D cup
If the overbust with breast forms measures smaller than the band, the cup will land at AA or A, which is normal for many men starting out. Once you have a starting size, find your next bra in our tested recommended bra options for men.
Verifying the Fit — Four Checks
Fasten the bra on the loosest hooks — bras stretch over time, and starting loose lets you tighten later. The band should sit horizontally across your back, parallel to the ground. If it rides up, the band is too big. About 90% of support should come from the band, not straps. You should be able to slide two fingers comfortably under the band. Adjust straps snugly but not digging. For underwire bras, the gore (center piece) must lie flat against your chest; if it floats off, the cups are too small or wrong shape. Reach into each cup from the top and scoop all tissue or forms forward so they sit fully inside the cup. Wires should not sit on tissue, float off, or dig in. Put a tight shirt on over the bra and check the silhouette. If you see red marks afterward, the band is too small — go up one band size and down one cup letter to keep the same volume.
Common Mistakes That Wreck the Fit
Measuring too high above the pecs is the most common error, making the band calculation wrong and guaranteeing discomfort. Over-tightening the tape during the underbust measurement does the same. Relying on straps for support is another pitfall; straps adjust fit, not carry weight. Never start on the tightest hooks — that eats adjustment room before the bra has stretched. With breast forms, choose a soft or thin bra style so forms sit naturally. The National Breast Cancer Foundation’s bra fitting guide is a strong resource for visual checks. US sizing usually follows the “+4” method, but brands vary — always check the specific brand’s size chart before ordering online.
FAQs
Should men add inches to the underbust measurement?
What cup size do most men start with?
Most men without breast forms or natural tissue start at AA or A cup. The difference between band and overbust measurement is usually small on broader chests. Starting small and adjusting upward prevents buying bras with empty cups.
Can a man wear a sports bra instead of a regular bra?
Yes. Sports bras designed for high-impact activity work well for men wanting compression, shape, or support without underwires. REI’s sizing guide recommends measuring the same way — underbust and overbust — then matching to the brand’s compression or encapsulation chart. Sports bras run snug, so consider going up one band size.
References & Sources
- National Breast Cancer Foundation. “Bra Fit Guide.” Official guide for measuring, fitting, and adjusting bras with illustrations.
- Wirecutter / New York Times. “The Right Way to Find a Bra That Fits.” Practical fitting advice for band and cup sizing.
- REI Co-op. “Sports Bra Sizing and Fit.” Expert advice on measuring and selecting sports bras.
