Car ramps are driven onto slowly and straight, then secured with the parking brake and wheel chocks before any work begins.
Getting a vehicle’s front wheels off the ground for an oil change or undercar inspection starts with one tool: a pair of car ramps. They’re simple to use, but the consequences of rushing the job range from a slipped wheel to a car falling while you’re beneath it. Drive onto the ramps, set the brake, chock the rear wheels, and add jack stands if you’ll be underneath. The steps below walk through the whole process, including the safety checks that make the difference.
Prepare the Ramps and the Ground First
Ramps only work when the surface works with them. Set both ramps on a hard, level, dry surface like concrete or asphalt. Grass, gravel, dirt, and wet or sloped ground let the ramps shift or sink under the vehicle’s weight, and that’s how accidents start.
Inspect each ramp before driving up. Look for cracks, bent edges, or worn grip surfaces, and confirm the set matches your vehicle’s weight and tire width. This preparation takes two minutes and prevents the entire class of ramp-related failures.
Position the ramps together, spaced exactly the width of your vehicle’s front tires, with the ramps parallel and pointing straight ahead.
The Drive-Up Process, Step by Step
Driving onto ramps is a slow, straight, controlled movement. Speed and steering input are the two variables that cause wheels to slip off the ramp surface.
- Align the vehicle so the front tires line up squarely with each ramp, and make sure the steering wheel is perfectly straight.
- Drive forward slowly, keeping the wheels centered on the ramps. Another person standing clear of the vehicle’s path can guide your alignment as you approach.
- Stop when the tires sit fully seated on the flat platform at the top of the ramps. The tires must not hang over the front edge.
- Shift into Park (automatic) or first gear (manual), then set the parking brake firmly.
Do not accelerate hard or brake suddenly while on the ramps. Both actions shift the vehicle’s weight abruptly and can push a wheel off its track.
Working Underneath: Use Jack Stands for Real Protection
Ramps support the vehicle’s weight, but they are not the recommended backup protection for anyone working underneath.
Several practical sources explain the advantage of ramps over floor jacks: the vehicle is already supported on both sides, leaving open space under the center for draining oil or reaching the transmission pan. Pair that access with jack stands set near the rated support points, and the setup becomes stable enough to work confidently.
Common Mistakes That Lead to Injuries
Most ramp accidents trace back to a small set of avoidable errors. These are the ones the safety sources highlight repeatedly:
- Setting up on uneven, soft, wet, or sloped ground, which lets the ramps shift.
- Misaligning the ramps so the tires ride the edge instead of the center.
- Skipping wheel chocks on the wheels still touching the ground.
- Driving up too fast or with the steering wheel turned.
- Trusting the ramps alone when working underneath, instead of adding jack stands.
Exiting the Ramps Safely
Removing the vehicle is the reverse of the drive-up, done just as carefully. Clear away tools, drain pans, and jack stands, then remove the chocks and release the parking brake. Back down slowly and straight, keeping the wheels aligned with the ramps until the tires reach flat ground.
If you’re ready to pick a set, our roundup of the best car ramps for oil change compares tested models by capacity, height, and build quality.
References & Sources
- ACCC Product Safety. “Portable ramps for motor vehicles guide.” Official safety guidance on ramp use, surface requirements, and load limits.
- iFixit. “How to Safely Raise a Vehicle Using Ramps.” Practical step-by-step instructions for safe ramp setup.
- 1A Auto. “How to Use Car Ramps.” Consumer guide covering ramp use for maintenance work.
