How to Use a Car Jack Stand? | Safe Lifting, Step By Step

Using a car jack stand safely means supporting the vehicle on a flat surface at its reinforced points after lifting it with a jack.

Working under a car held up only by a hydraulic jack is one of the most preventable garage accidents there is. Jacks are for lifting; jack stands are for holding. The difference saves lives. The sequence below walks through the correct way to position, set, and verify jack stands so you can work underneath with confidence.

Before You Lift: Setup And Preparation

Preparation prevents the two biggest failures: the car rolling and the stands sinking. Start by parking on a flat, solid surface. Concrete is ideal; dirt, gravel, and slopes are dangerous because stands can sink or the vehicle can shift. Soft asphalt is also a risk, as it can soften and allow the stands to press in.

Secure the vehicle before lifting anything:

  • Set the parking brake firmly.
  • Put an automatic transmission in Park, or a manual transmission in gear.
  • Place wheel chocks against the wheels that stay on the ground. If you’re lifting the front, chock the rear wheels, and vice versa.

Open the owner’s manual and find the designated jacking points and support points. These are reinforced areas designed to take the vehicle’s weight. Common safe spots include frame rails and reinforced pinch welds. Never use weak body panels, oil pans, or transmission pans—they will crush or buckle.

The Correct Lifting And Lowering Sequence

With the vehicle secured, position the floor jack under a manufacturer-approved front or rear jacking point. Pump the handle to raise the vehicle until there’s enough clearance to slide the jack stands underneath. You should only need to lift it a few inches higher than the stand’s set height.

Set each jack stand to the same height before positioning them. Place the stands under the vehicle’s designated support points, not the same spot used for the jack if it isn’t reinforced for static support.

Lower the vehicle slowly and evenly so its full weight rests on the stands. Once it’s down, remove the floor jack from its load-bearing position.

Safety Rules And Common Mistakes To Avoid

The rules are simple, and each one has a corresponding mistake that causes accidents. Follow them without shortcuts.

Rule Why It Matters
Never work under a car supported only by a hydraulic jack Jacks can fail or leak; stands are the load-bearing support.
Use stands in matched pairs for one end of the vehicle Mixing ratings or using a single stand makes the load unstable.
Keep the vehicle level and balanced on the stands An uneven load can shift and drop the vehicle.
Confirm the combined load rating exceeds the vehicle’s weight Overloaded stands can fail suddenly.
Wear eye protection and sturdy footwear Debris and dropped tools are real hazards under a car.

Skipping the wheel chocks is one of the most common mistakes, especially when only one end of the car is in the air. Failing to check that the locking mechanism is fully engaged is another. And never apply heavy torque or horizontal force to the vehicle while it’s on stands—that’s what a proper workshop lift is for. If a job requires serious leverage, the car belongs on a dedicated hoist, not on stands.

These instructions apply to passenger cars and light trucks with manufacturer-approved lift points. The exact support points and the number of stands required depend on your vehicle’s design, so the owner’s manual is always the final authority.

References & Sources

Please use a real email you check. If it's fake or mistyped, your message won't reach us and we can't reply — wrong addresses are rejected automatically.