7 Best Antenna Splitter Amplifier | One Feed, Four Clean TVs

Check Price on Amazon

A four-way amp that hands each TV +7.5 dB and still lets your cable modem talk back to the street.

The Antronix MRA4-08/AC is the pick for anyone whose line carries both cable TV and an internet feed. Its four ports each receive a +7.5 dB boost, and the whole box is rated from 5 to 1002 MHz, which reaches the long-wavelength UHF channels that tend to weaken on long runs. Because it taps a passive return path, a cable modem on the same line keeps its upstream channel — that is the single feature most cheap splitters strip out. Housing is nickel-plated for corrosion resistance, and it carries 6 kV surge protection on every port, which is meaningful when the amp lives outside near a coax drop.

Owner feedback splits cleanly: channel availability and picture quality are the two most-mentioned positives, and cord-cutters who feed several TVs off one outdoor antenna report getting roughly 60 channels per set with no pixelation, even mounted in a watertight box through Georgia mountain temperature and humidity swings. One buyer who came to this amp to fix Xfinity and TiVo pixelation on certain HD channels put a powered amp at the entry point with 75-ohm terminators on the empty ports and the problem cleared. That same buyer’s honest warning is worth reading twice: an amplifier boosts the signal you bring it, but it cannot repair a signal that was already bad.

Where the feedback gets murkier is raw signal quality — some owners see a clean lift, others see no improvement at all, and a small number report no gain worth keeping. That tells you more about the installer than the product: this amp’s job is to preserve a good signal across a four-way split, not to rescue a dead one. If your local station is already out of reach, no four-port amplifier will magically pull it in — that is a preamp-and-antenna problem. Five-year warranty on the amplifier itself and a self-resetting, UL-rated power adapter finish the package.

Check Price on Amazon

The equalizer is the trick here — it boosts weak high-frequency channels harder than the strong low ones.

Every amplifier in this list lifts the whole band, but this one shapes it. The integrated equalizer gives minimum gain of +0 dB at 54 MHz up to +7.5 dB at 1000 MHz — meaning the higher-frequency signals that fade fastest on long cable runs get more help than the low-frequency ones that arrive strong anyway. That is the right answer for a home where the antenna sits at one end and the longest coax run snakes to the far bedroom. Its operating range of -40 °C to +60 °C (-40 °F to +140 °F) and 15 PSI weather-tight seal means it is rated for hostile outdoor placement, and it carries 6 kV ring wave surge protection against voltage spikes. The four ports plus passive return path make it a reasonable fit for a shared cable-and-internet feed, and it weighs in as a genuinely compact metal box.

The standout trait, echoed across owner feedback, is quality — this unit feels substantial and mounts cleanly with grounding points and a DC-to-F adapter in the box. One buyer with a four-bay attic antenna feeding 75 feet of cable to two TVs reports rock-solid reception for more than three years on low-loss RG6, and another cleared static and noise while going from 60 to 67 channels. A suburban owner with four TVs asked the classic question — will four outputs overpower the signal? — and found this amp handled the split without trouble. When the input signal is clean, the equalizer’s shaping does exactly what it claims.

The honest trade-off is that this amp cannot save a bad input. Owners who fed it a weak or noisy antenna signal — one user came off a seven-year-old degraded amp with a passive preamp still attached — found they had to rip the preamp out before the channels came back. Feed it a clean line and it delivers nearly a hundred clear channels; feed it garbage and it just amplifies the garbage. Also worth noting: no connecting cables are included, so budget for coax and a power adapter cable if you do not have spares.

Check Price on Amazon

Built for the house at the end of a very long driveway, where the drop signal arrives half-dead.

Distance from the pole is the enemy of a clean cable picture, and this box is aimed straight at it. The MRA4-8 is a four-port amplifier with a passive return path, +7.5 dB of gain on each output, and a compact footprint that measures just 4.5 × 3.25 × 0.8 inches — which means it slots into a tight wiring panel without a fight. A 36-inch custom coaxial power cable is included, along with two 75-ohm port terminators to cap the outputs you leave empty, so you can have it mounted and running the same day the box arrives. It is also rated 6 kV against lightning surges, with a nickel-plated housing that resists salt fog and rust if it lives near a coastal or salty environment.

What owners like most is the picture. One buyer located 75 yards from the pole reports this amp works better than what the cable company itself installed. Others describe their channels arriving clearer and more reliably, even during bad weather, all running inside the house. That is the value story in one line: it takes an over-long drop and hands the boxes at the end of it a signal they can actually lock onto. Build quality draws consistent mention too, and the self-setting circuit protection in the power adapter keeps a shorted port from taking the whole system offline.

Two realities to weigh. First, this is a distribution amp, not a channel-extender — owners mention holding the same clear picture on the channels they had rather than adding new ones, so do not buy it expecting brand-new stations to appear. Second, durability is a mixed bag in the longer-term ownership reports; the box is well made, but some users have seen an amplifier fail over time, so treat it as a replaceable piece of gear rather than a forever part. Meanwhile the raw signal-strength gain splits down the middle in owner feedback — the honest reading is that it shines when the incoming signal is decent but long, and does less when the signal arrives already weak.

Check Price on Amazon

One of the few four-way amps here that reaches high enough to feed a gigabit modem and three TVs at once.

This one stands out for the modem crowd. The Lindsay LSA84 delivers 8 dB of gain across its four ports, with the same 5–1002 MHz frequency range as the Antronix and the same passive return path that keeps an upstream cable-modem signal intact. Multiple owners single out the fact that it supports the higher frequencies gigabit service needs — a feature plenty of cheap splitter amps quietly lack. It is a 75-ohm unit built into a black metal housing, and it comes with an amplifier, power supply, and two 75-ohm terminators. Its 6 kV ring wave surge design and 15 PSI weather-tight seal make it a legitimate outdoor candidate if you mount it in a sheltered spot.

Functionality and channel reception are the two most-discussed positives. A user fighting Comcast pixellation on three TVs and a modem dropped this amp plus a short RG6 power cable at the entry point and cleared the whole house, sidestepping a full RG6 rewire. The most striking before-and-after in the feedback comes from a two-way-to-four-way swap on an attic antenna: reception went from about 60 glitchy OTA stations to 140 crisp ones across all TVs. That 140 number is the strongest single result in this entire list, and it comes from doing the boring things right — capping unused ports and keeping the input clean.

The trade-off here is setup precision. This amp refuses to sit behind another amplifier or preamp, cannot touch satellite systems, and is not compatible with MoCA (a standard that carries internet traffic over coax alongside TV). Multiple owners note that you must cap any unused ports with the included terminators or the signal degrades — and if the incoming signal is already weak, this amp will only pass that weakness through. It is not a fix for a bad antenna, just a clean way to distribute a good one. No power cable is included in the box, so add a short RG6 run if you do not have one spare.

Check Price on Amazon

For the rural setup where every other booster failed, and the built-in 5G filter stops phone interference cold.

This is the pick for the tough-reception house — the rural property, the tree-blocked lot, the home ninety miles from the nearest tower. The Channel Master CM-3424 is a four-port distribution amplifier with 7.5 dB of gain per port, rated 75 ohms, and engineered exclusively for over-the-air TV antennas — it will not pass cable or satellite signals at all. what separates it is the built-in LTE filter, which strips out the 5G and cellular-band interference that can smear an otherwise good picture. It also carries that old-school nameplate: Channel Master has been in the TV antenna business since 1949, based in Arizona.

Signal strength and channel count are, by a wide margin, the two things owners talk about most. One rural buyer who had tried roughly six boosters with no result reports this amp lifted reception by 40–50% with zero other changes, and it now feeds three TVs. A buyer with an antenna on a 40-foot tower ninety miles from the stations describes the SNR (signal-to-noise ratio, a measure of how much usable picture sits above the background noise) climbing from a 15–17 range to 18–22, with the TV’s own tuner turning its internal boost down by half. Most striking: that same buyer reports the LTE filter wiped out 5G interference entirely. Another owner moved from 45 to 97 channels across all four TVs after the swap. This is a genuine coverage-lifter, not just a splitter.

The honest limitation is that this is designed for antenna systems, not cable — pairing it with a cable or satellite feed is an outright non-starter. It is also a distribution amplifier, not a preamp: the manufacturer explicitly says it is not meant to rescue a weak-signal area, and should not be used as a preamp. Owners pushing their line toward very distant weak stations report modest gains of a few points on the meter. Mounting requires an outlet and coax skill outdoors, so factor in weather protection if you place it in an exposed spot.

Check Price on Amazon

A four-output amp that reaches to 1.2 GHz, so it splits CATV and broadcast TV off the same line.

The JUICE4 is the generalist of the group — good at OTA, capable with legacy CATV and cable-broadband distribution, and compact enough to tuck almost anywhere. Where the Antronix and Reliable amps stop at 1002 MHz, this Antennas Direct unit extends its operating frequency to 1.2 GHz to accommodate CATV and cable broadband applications, which is a real advantage if your line carries both. Its four outputs feed up to four TVs or digital converters, and it supports the newer ATSC 3.0 NEXTGEN TV standard along with 4K and 8K UHD — future-facing features the more traditional amps in this list do not advertise. The housing is precision machine-sealed zinc diecast, protecting against dust and water droplets while shielding against electrostatic discharge, with excellent surge protection on all ports. It is 9.6 ounces and rated 75 ohms.

The trait owners praise most is signal quality, followed closely by build quality. Whether you are clearing a low-signal problem or feeding four smart TVs, the reports are consistent: hook it up and the pixelation stops. One buyer picked one up after their old amplifier failed and reports getting 60-plus stations back. Another describes it working perfectly as a preamp feeding a long cable run. Several owners note that the box gets warm to the touch but not hot, and that installation is quick and clean. It even works well over a long stretch of cable mesh — an owner using it over a lengthy coax run reports the signal pushing through without skipping or spidering. If you want one box that handles antenna and cable-broadband at once, this is it.

Two caveats worth knowing. There is a small handful of stories about early failure — at least one owner reports the unit became glitchy after about five days, though that appears to be a rare single-unit issue. And its frequency range makes it the priciest pick here, so you are paying a premium for the extended-range versatility. For users who only run four TVs on a plain antenna with no cable service, you may not need the 1.2 GHz reach.