An engine hoist works by using a manually pumped hydraulic cylinder to raise a boom, which lifts the engine via a chain or hook.
An engine hoist—also called an engine crane or cherry picker—is the portable lifting tool that lets one person pull a motor out of a car. The whole system runs on a simple hydraulic principle that’s been standard for decades, and understanding it makes the tool safer to use.
If you’re shopping for one before your next swap, our tested roundup of the best 2 ton engine hoists covers what’s worth your money.
The Hydraulic Core: What Powers the Lift
When you pump the handle, you’re forcing hydraulic fluid out of a reservoir and into a cylinder. That fluid builds pressure and extends a ram, which pushes the boom upward. Open the release valve and the fluid flows back, letting the load lower gently. That’s the entire mechanism.
The key parts are simple: a steel base with casters, front legs, a boom, the hydraulic jack, and a chain or hook at the end. Most hoists let you adjust the boom’s extension, which trades capacity for reach—extending it further reduces how much weight you can safely lift.
How to Use an Engine Hoist Safely
Using one correctly is about planning, not strength. The hydraulic cylinder does the heavy work; your job is to keep the load stable and controlled.
Start by clearing the work area and mapping the removal path. Then disconnect everything attached to the engine—hoses, wiring, mounts—so the motor hangs free. With the hoist positioned, choose the boom setting that fits the load and connect the chain securely to the engine’s designated lifting points.
Close the release valve, then pump slowly. Once the chain takes up slack, lift just an inch or two and stop. Check the balance and the security of the attachment before going higher. Raise gradually, watching for snagged lines or hardware, and use the release valve—not force—to lower the engine under control.
Capacity and Stability Limits
An engine hoist’s rating only means something when the boom is in the right configuration. The effective capacity drops as the boom extends, so check the setup before you lift.
The base does more than hold the wheels. The front legs spread the weight and keep the hoist from tipping, so position them squarely under the load. A swinging or off-center engine can turn a quick job into a dangerous one, which is why slow, steady motion matters as much as the hardware itself.
Common Mistakes to Avoid
Most engine-hoist accidents come from rushing. Here are the failures that show up again and again:
- Lifting before every hose, wire, and mount is disconnected.
- Hooking the chain to weak or wrong lift points.
- Overextending the boom beyond the safe rating for the engine’s weight.
- Pumping fast and skipping the balance check after the first inches of lift.
- Opening the release valve too quickly and dropping the engine hard.
None of these are exotic failures—they’re the normal result of skipping a step. The fix is simple: plan the lift, secure the load, and move the valve slowly.
References & Sources
- The Drive. “How to Use an Engine Hoist.” Details the direct operating principle, steps, and common mistakes in using a hydraulic engine hoist.
