How Many Gallons Is an 18×48 Pool? | Volume by Model

An 18-foot round above-ground pool with 48-inch walls holds roughly 6,100 to 6,400 gallons at the standard 90% fill level, depending on the manufacturer.

If you’ve just bought or set up an 18×48 pool and need to know its exact water capacity for chemical dosing, you’ve found the right numbers. The answer isn’t a single figure — it depends on which model you own and how full you fill it. Below are the exact volumes for the two most common brands, the math behind them, and the mistakes that cause the most problems.

Exact Volume by Brand and Fill Level

Most pool manufacturers and maintenance guides recommend filling to about 90% capacity — roughly 3 to 4 inches below the top rail. This leaves room for displacement without overflow during use or rain. Here is how the two leading 18×48 round pools measure up at that level.

Pool Brand & Model Volume at 90% Fill Diameter x Wall Height
Intex Prism Frame 18′ x 48″ 6,423 gallons 18 ft × 48 in
Bestway Steel Pro MAX 18′ x 48″ 6,092 gallons 18 ft × 48 in

But almost nobody runs a pool that full — and you shouldn’t, because the over-chlorination risk is real.

How the Volume Is Calculated

Using the rectangular one (7.5) will overestimate your pool’s volume by about 27% — a common and costly mistake when you’re adding chemicals.

Round pool formula: (Diameter in feet)² × Depth in feet × 5.9 = Gallons

The small difference between that number and the brand-specific figures above comes down to liner design and exact interior dimensions.

Every inch of wall height matters, so measure your actual water depth rather than trusting “48 inches.” If your pool is only filled to 42 inches, for example, plug 3.5 feet into the formula instead of 4.

Mistakes That Throw Off Your Numbers

Using the wrong multiplier. This is the most common error. Round pools use 5.9; rectangular pools use 7.5. Applying 7.5 to a round 18×48 gives you 9,720 gallons — a number that would lead to serious over-dosing. The 5.9 multiplier accounts for the geometry of a circle (πr²) converted to US gallons.

Filling to 100%. Besides the overflow risk, a pool filled to the brim gives you no margin for rain or swimmers. The 90% fill is standard across the industry for a reason: it’s safer and more practical. All major chemical dosing guides assume this level.

Confusing 18×48 with a rectangular pool. The term “18×48” almost exclusively refers to an 18-foot round pool with 48-inch walls. An 18-foot by 48-foot rectangular pool would hold over 45,000 gallons — a completely different piece of equipment.

Why Getting the Right Number Matters

Your pool’s filter pump needs to circulate the full volume at least once every 8 to 12 hours. The Intex Prism Frame ships with a 1,500-gallon-per-hour pump, which is correctly sized for a 6,423-gallon pool. If you swap to a different filter, match its flow rate to your actual fill volume.

Water weight is another practical concern. A gallon of water weighs about 8.34 pounds. A pool holding 6,400 gallons puts roughly 53,000 pounds (about 26.5 tons) on your installation surface. Your ground prep — level, compacted, clear of rocks — needs to support that load evenly.

When you’re ready to buy, our tested roundup of the best 18 x 48 pools compares the Intex, Bestway, and other top models side by side.

FAQs

Does an inflatable 18×48 pool hold fewer gallons?

Yes. Inflatable pools with inflatable top rings or curved walls often have less effective depth than rigid-frame models. Because the wall isn’t vertical and the ring reduces usable water depth, the formula above overestimates their volume. Contact the manufacturer for the specific capacity of inflatable models.

Can I use the same chemical dose for every 18×48 pool?

No. The 6,092-gallon Bestway and the 6,423-gallon Intex need different doses. Always dose based on your brand’s exact 90% fill figure. Using a generic “18×48” number will under- or over-dose by roughly 5% — enough to cause poor water quality or liner wear over a season.

How much does the water in an 18×48 pool weigh?

At 90% fill, the water weighs between 50,800 and 53,500 pounds (roughly 25 to 27 tons). This load must be supported on level, compacted ground. Never place an 18×48 pool on a deck, rooftop, or ungraded lawn without verifying the surface can hold the weight.

References & Sources

Please use a real email you check. If it's fake or mistyped, your message won't reach us and we can't reply — wrong addresses are rejected automatically.