Blackout curtains block 90–100% of outside light when chosen by rating, sized 1.5–2 times the window width, and mounted high with full edge coverage.
Choosing blackout curtains starts with one question: is the goal total darkness for sleep, or just glare and privacy? That answer decides whether you need true blackout fabric or a room-darkening panel, and it shapes every other choice — width, mounting height, and hardware. The right setup turns a bedroom or media room properly dark; the wrong one leaves light leaking around the edges no matter how thick the fabric looks.
Blackout vs. Room Darkening: Know the Difference
True blackout curtains are engineered to block 90–100% of incoming light, usually with a dense weave or a coated backing. Room-darkening curtains are lighter, blocking roughly 70–85% of light, and they suit living rooms or spaces where some daylight is welcome. Sellers are not consistent with these terms, so check the listing for a stated light-blocking percentage before buying. If one is missing, ask the seller directly rather than assuming.
For bedrooms, nurseries, and media rooms, prioritize true blackout construction with a lining or backing. Wirecutter and Consumer Reports both test these panels by measuring actual light transmission, and both emphasize that a built-in blackout layer outperforms a merely thick weave. When a listing says only “heavy fabric” without a rating, treat it as room-darkening at best.
Measure and Mount to Eliminate Light Leaks
Speed of installation matters less than coverage. The common mistake is buying a panel that matches the window frame exactly, which leaves bright gaps at every edge. Follow these sizing and mounting rules instead:
- Width: Buy curtains that total 1.5 to 2 times the window width for proper fullness and side overlap when closed.
- Rod extension: Extend the rod 4 to 6 inches past each side of the frame so the fabric clears the trim and blocks edge light.
- Mount height: Install the rod as high as possible — close to the ceiling — so no light spills over the top. If you can, run a track the full width of the room.
- Length: Choose panels that reach the floor or at least well below the window sill so no light enters at the bottom.
After installation, test the result in a dark room or at sunrise. If light shows at the edges, add a wrap-around rod, side channels, or a second overlapping panel to seal the gaps.
Fabric, Care, and Hardware That Hold Up
Blackout performance also depends on the fabric’s backing and how you maintain it. Engineered blackout fabrics with a dedicated lining perform better than unbacked weaves, and they are often dry-clean only. If you want machine-washable panels, check the care label for a gentle cycle setting — and never iron synthetic blackout layers unless the label allows it, since heat can damage the coating.
Heavy lined curtains are genuinely heavy, so secure hardware matters. Use ceiling mounts or extra wall brackets rated for the panel weight to prevent sagging over time. While shopping, consider a flashlight test on any panel you’re unsure about: hold it up to a strong light and see how much shines through. One source also notes that some blackout shades use chemical coatings, so if material safety is a concern for a nursery, look for panels that advertise their coating or construction.
A final practical note: 100% darkness is not always the right target. In a bedroom, a sliver of ambient light helps with nighttime navigation, so decide whether you want a fully sealed room or a slightly softer effect before you commit to side channels and full ceiling tracks. If you’re outfitting a large window, our tested roundup of 120 inch blackout curtains shows which extra-wide panels actually block light without sagging.
FAQs
Do blackout curtains also block heat and noise?
Blackout curtains with thick linings do add some insulation, which can reduce heat transfer through windows and slightly dampen outside noise. Thermal performance depends on the fabric weight and lining material, so check the listing for insulation claims if that matters to you.
Can I wash blackout curtains in a washing machine?
Some can, but only on a very gentle cycle and only if the care label allows it. Many blackout panels are dry-clean only because the backing coating can crack or peel with agitation. Always check the label before washing, and never iron synthetic blackout layers.
How do I stop light from coming in around the sides?
Extend the rod several inches past the window frame on each side, and choose panels wide enough to overlap when closed. For maximum darkness, use a wrap-around rod or a track that spans the full window width so the fabric seals against the wall.
References & Sources
- Wirecutter (The New York Times). “The Best Blackout Curtains.” Tests panels for actual light transmission and covers sizing and mounting guidance.
- Consumer Reports. “Best Blackout Curtains of the Year.” Ranks panels by measured light-blocking performance and fabric quality.
- Lowe’s. “Blackout Curtains Buying Guide.” Explains blackout vs. room-darkening ratings and installation best practices.
