How to Tie Rope to Anchor | Secure Boat Knots

Two knots—the Anchor Bend and the Anchor Hitch—are the standard ways to tie rope to a boat anchor, both using two wraps around the shackle and a securing half hitch.

Dropping anchor is simple; trusting your knot to hold through current and tide is the real skill. That same knot keeps the boat in place while you fish, eat, or sleep. The right tie—the Anchor Bend or the Anchor Hitch—distributes the load and tightens under pressure instead of slipping. Both use the same core sequence of wraps and hitches, and both need one more step most people skip: seizing the free end so it can never loosen.

Anchor Bend: The Primary Knot

The Anchor Bend (also called the Fisherman’s Bend) is the standard maritime knot for attaching a line to a ring or shackle. Its two wraps around the hardware create the friction that holds the load, and a final half hitch prevents the knot from working open under wave motion. The steps are straightforward.

  1. Wrap twice. Pass the rope’s working end through the anchor’s shackle or eye two times, leaving the turns loose. These two wraps are the holding power of the knot—one wrap is not enough friction.
  2. Feed through. Take the free end behind the standing line (the part running toward the boat) and pass it through the first set of wraps just created around the shackle.
  3. Tighten. Pull the working end to draw the bend snug against the hardware.
  4. Hitch. Wrap the working end around the standing line once to form a half hitch. Pull this tight.
  5. Secure the tag end. This is the step beginners miss. Wrap the leftover tail tightly around the standing line—this seizing prevents the knot from untying itself under load. Alternatively, tie one half of a Double Fisherman’s knot as a backup.

Anchor Hitch: The Practical Alternative

The Anchor Hitch is functionally identical to the Anchor Bend but arranged for hitching to a shackle rather than a ring. Many marine guides treat the names interchangeably, but the hitch version uses the same two-wrap-and-pass sequence.

  1. Start with the shackle. Never tie directly to the anchor’s metal—always use a shackle or swivel between the rope and the anchor. Tying direct risks fraying the rope and creates a point of failure.
  2. Wrap twice around the shackle or swivel with the working end.
  3. Pass the working end through the loops you just made.
  4. Tighten the knot firmly.
  5. Hitch the working end around the rope’s standing part, then pull up on the working end while holding the shackle to set the knot. Seize the free end to the standing line for long-term security.

Rope, Hardware, and Scope Requirements

The knot is only part of the system. The rope itself, the connector, and the amount of line you let out all matter for a secure hold. Nylon line is the standard choice for anchor rode because its elasticity absorbs shock from waves and wind. The rope length—called scope—should be at least three times the water depth where you anchor. Use a D-shackle on both ends of the rope; splicing an eyelet into the rope end lets the shackle join the assembly cleanly.

Common Mistakes and How to Avoid Them

Three mistakes cause most anchor-knot failures. Tying directly to the anchor metal instead of using a shackle damages the rope and can cause sudden failure under load. Skipping the seizing step lets the knot loosen as the boat swings. And using only one wrap instead of two removes the friction that keeps the load from slipping. The final half hitch must also be pulled tight—a loose hitch lets the whole knot work open.

References & Sources

Please use a real email you check. If it's fake or mistyped, your message won't reach us and we can't reply — wrong addresses are rejected automatically.