Using a knife sharpener means pulling the blade heel-to-tip through the sharpening slot with light, even pressure until a burr forms, then finishing in finer slots.
For the full breakdown, see our best Affordable Knife Sharpener guide.
Most pull-through and electric sharpeners do the angle work for you, so the technique comes down to a steady hand and the right order of stages. Whether you’re reviving a dull chef’s knife or maintaining one that’s still sharp, the same core motions apply—start coarse, finish fine, and let the sharpener’s built-in guides set your angle. If you’re shopping for your first model, our roundup of the best affordable knife sharpeners covers tested budget picks.
Setting Up for Sharpening
Place the sharpener on a flat, stable surface before you do anything else. A cutting board or countertop that won’t rock under pressure keeps the blade angle consistent through every pass. Hold the sharpener’s base firmly with your nondominant hand so the unit doesn’t shift mid-stroke.
Check the slots before you begin. Most pull-through sharpeners have two or three stages, usually labeled or arranged from widest to narrowest. The coarse slot removes metal and repairs dull edges; the fine or honing slot refines that edge; a stropping or polishing slot, when present, finishes the job last. Some compact designs like OXO’s slide the slots into the handle for storage, so confirm which slot is which before starting.
The Pull-Through Technique
Insert the knife’s heel—the part of the blade closest to the handle—into the first slot, perpendicular to the sharpener. Pull the blade toward you in one smooth motion, and lift the handle slightly as the tip approaches so the full edge contacts the abrasive. Repeat this three to five times per slot, per side, adjusting for how dull the blade is. Do not go back and forth; pull-through slots sharpen in one direction only.
KitchenAid’s official instructions for its built-in knife sharpener echo this: place the heel in the slot and pull through with slight downward pressure, never back and forth. OXO’s guidance adds a similar note: center the heel in slot one, pull in one slow, smooth motion with firm, even pressure, repeat three to four times, then hone in slot two with a single stroke. After sharpening, KitchenAid recommends hand washing with warm water and mild detergent, rinsing, and drying immediately.
Keep your fingers clear of the edge and the slot opening. Use light, consistent pressure—forcing the blade grinds away more metal than needed and can chip the edge.
Electric, Whetstone, and Special Cases
Electric sharpeners follow the same coarse-to-fine logic but add a motor. Turn the unit on, insert the blade into the first slot, and pull it through slowly without rushing or forcing it, then move to the finer slots. Let the machine’s pull rate set the pace. Whetstones and other manual systems share the same goal but require you to hold the angle yourself; a honing rod or steel, meanwhile, only realigns an already-sharp edge—it removes no metal and is not a substitute for sharpening.
FAQs
How Many Times Should I Pull the Knife Through?
Should I Sharpen in One Direction or Back and Forth?
What’s the Difference Between Honing and Sharpening?
References & Sources
- Michigan State University Extension. “Knife Sharpeners 101.” Covers sharpener types, technique, and common mistakes.
- KitchenAid. “Knife Sharpening Instructions.” Official step-by-step for the built-in sharpener, including the single-direction pull and cleaning guidance.
- Zwilling. “Use & Care: Knife Sharpening.” Details honing versus sharpening and proper care after use.
